Cisco 7941G-GE IP Phone "poe" Questions

...boot frequently.. Wat may be the cause.. and solution... reset it Are you powering the phone via PoE from the switch? If so, it might be pushing PoE that the phone is not completely happy with.

...your attention i found the solution, the ethernet cable was able to transmit IP traffic, but not POE, may be one of the 8 wires was defective it's ok now with a new cable, connected on a POE port ...

Ethernet Disconnected message in POE 7941G IP Phones Hi, I am facing an issue with one of my cisco IP Phone in my office. The Phone is not connecting to the network and it is displaying a message ...

... my cisco ip phone does not start Confirm if the Phone has power supply. and If it's connected to a POE switch confirm that it connects to the Switch port on the phone. Yes, if you are using a Cisco ...

...to it? If so, try another one if possible as it could be the defective component. If you're using POE to power it, make sure you have pluggd into a POE port for sure. If you still have problems ...

...power over ethernet configured switched on. i have a problem with my phone Could be issues with the PoE power source on your switch. Sometimes the PoE components stop working and do not generate ...

...QOS. What does a data vendor need to do when setting up his switch "auto qos voip cisco-phone" on poe port, "auto qos voip trust" on both ends of the uplink

...to factory defaults and reprogrammed. To stop the reboot cycle, try this: - Connect the phone to POE (Power Over Ethernet) injector, but do not plug in a data cable into the injector. - When the ...

correct port (not the PC port)? The phone requires Power Over Ethernet - this is either done with a PoE Switch or PoE injector. This should provide power to the phone so it can boot

I have upgraded my 3550 to a 3560v2 48portPOE and can not get my cisco 7940G to power up. The switchport is green but when I look at the power inline log it does not see the phone or that it is a POE ...