Question about Mitsubishi Televison & Video
...put in. Metronet has the following: Press and hold setup until led light blinks twice. press a mode key tv dvd aux. press and hold ok key until the device turns off. Other suppliers, your on your
Question about Westinghouse Electric Televison & Video
...IS BAD? SOUND WORKS FINE. TURN OFF AND WAIT 15 MINS PICTURE IS FINE. ON AN OLD TV I WOULD THINK THE HORIZONTAL HOLD WAS NOT WORKING horizontal sync missing check defflection circuit for bad ...
Question about Westinghouse Televison & Video
...Hold [menu] and [vol-] button on the side of the TV 2. while holding these, press the [power] button on the side of TV (NOT remote) 3. blue light comes ON and stays ON 4. wait 10 seconds then let go ...
...of your tv? Might be a backlight inverter issue. Hold a flashlight up to your tv screen when the tv is turned on, if you can see picture....this is more than likely the issue. ...
the tv LCD screen panel to hold on to give the tv screen panel to have pictures only.Tries websites like Shopjimmy.com,EBAY.COM to those refurbishes 1 or 2 long LCD inverter boards for the replacement
tv hold power button for 5 sec on tv then let go plug in and start. If that dont work unplug and then plug and hold power button on tv for 5 sec. It is 1 of those combinations. My tv worked after that
...hand corner just keeps blinking Unplug TV, Plug back in. Hold menu and -vol buttons. Push power button and release it. keep holding the 2 buttons for 5 sec. release both button and TV should come
...TV - then hold in the power button (usually found on left side 1/4 up from bottom of screen , located on the side/back of the set. a square button all alone) - hold power button in for 30 1,000 ...
Question about Westinghouse Televison & Video
...hold [menu] and [vol-] on TV side panel 2. press and release [power] on TV side panel 3. count to 5 and release[menu] and [vol-] 4. TV should have turned on 5. if not, unplug TV and press[power] 6. ...
...tv L26HD35D has no picture but i 2007 35" rca lcd tv L26HD35D has no picture but i hear sound. I can solder and even replace a pert but i dont know what needs yo be done. Thankyou Sounds like it ...
77 questions posted
Usually answered in minutes!
469 Questions
238 Questions
97 Questions
100 Questions
66 Questions