...fan is not working. The fan removes the heat from inside the unit to cool it. no fan, no cool. Your local appliance repair can fix it. the fan does not cost much and there isn't much labor involved. ...
Question about Danby Furniture
...fan inside, use a thin bladed knife or razor blade to delicately separate the top from the sides. Before replacing fans, try tracing the leads from the fans to the PC board and swapping the plugs for ...
Question about The Wine Enthusiast Furniture
...in the compartment not cooling. If not, check the wires / connection of fan or replace the fan. If the fan is working than the issue may be with the THERMO ELECTRIC ELEMENT. you'll need to replace
...fan is not working The HVTS18DABB wine chiller is truely a piece of **** when it comes to their fans. I have had top fans in the top chiller fail. Solution: Don't buy the replacement ...
...is less than a year old and the fan stopped working. The lights still work, but the temp is now 74. Without the fan it won't pass the proper airflow accross the coil, the fan needs to be
...fan is not working? If this is the problem then sounds like one of the two fuses in back panel has burnt out. The outside rear fan on my wine cellar seized and caused the unit to stop working. I ...
fan not working My wine cooler is not cooling at all. It has three fans inside it and one is not running. I have switched the fan connection at the circuit board and the non-working fan starts right ...
I have a Haier HVTS18DABB wine cooler and the upper fan stopped running. If I unplug and switch fans so the upper is now the lower, and vice versa, still the upper level fan does not run. By doing ...
fan should also be working (most of the time). 4) If one of the fans is not working or the compressor is off, the unit will offer very little cooling or none at all. hope you will be helpfull.. Thanks
Question about Haier Furniture
...fan is not working and is heating up top compartment. The fan seems to be stuck. remove the back metal panel and unscrew the top fan and unplug the terminal the cable plugged into the board. I spread ...
107 questions posted
Usually answered in minutes!
168 Questions
2 Questions