Question about Haier Furniture
...top fan is not working and is heating up top compartment. The fan seems to be stuck. remove the back metal panel and unscrew the top fan and unplug the terminal the cable plugged into the board. I ...
...hot , not cooling below 79 degrees the top fan is not suppose to run all thetime only when its too cold and the heater kicks then the top fan will come on,you probley have a leak in the ...
top fan is not working The HVTS18DABB wine chiller is truely a piece of **** when it comes to their fans. I have had top fans in the top chiller fail. Solution: Don't buy the ...
TOP EVAP FAN NOT RUNNING THE TOP EVAP DOES NOT RUN NO MATTER WHAT. THE COMPRESSOR COMES ON AND RUNS OK AND THE OTHER LOWER FANS RUN OK JUST THE TOP ONE DOES NOT RUN. IF I NEED ONE WHERE CAN I FIND ONE
Question about Danby Furniture
...fan inside, use a thin bladed knife or razor blade to delicately separate the top from the sides. Before replacing fans, try tracing the leads from the fans to the PC board and swapping the plugs for ...
Question about Danby Furniture
...top of the fan that is holding the temperature sensor in place. Remove the 4 screws from the underside of the fan that are holding both the fan and fan guard in place. Other than the wire going under ...
...top-rear fan on the wine fridge. Pumping air directly over the heat sink allowed the unit to attain the temperature set on the front panel. The old fan would either not turn at all, or too slowly to ...
fan top back of unit is on and off continuely and making noise as in a failing bearing. I have removed the retaining screws, however the wiring has no disconnect to permit removal from the fan. ...
Fan runs, but why doesn't top temp go below 75? Fans run, temp not stable, don't know how to adjust temp, need a manual and idea on how to fix We would need more info. what model or size, or you might
Question about Breezaire Furniture
How do you open cabinet to replace fans on a Breezaire WK2200 unit? YOU WILL HAVE TO DRILL OF THE RIVETS ON THE SIDES OF THE UNIT USING A 1/8 DRILL BIT, ONCE YOU DRILLED THEM OF YOU WILL TAKE OF THE ...
107 questions posted
Usually answered in minutes!
168 Questions
2 Questions
