Kenmore 46462 Front Load Washer "tup" Questions

first service call at 2 years. could be the tub hub is their alot of movement if you pull up on the tup more then 1-1/2

The inner tup on my whirlpool washer is loose. The washer does not spin the clothes as dry and sounds unbalanced when it spins. How do we tighten the inner tub? look at this part at ...

How do I get all the stains and crud/mold off the front side of the whole tup enclosure.?? The grey rubber outer ring ?? I can't seem to keep this clean, and it actually turns the grey rubber ...

...should do this job. You can seriously hurt yourself attempting this repair. Also see if the inner tup is turning as it agitates, if it is then it i definately the brake. But one more time do not

...It does everything else seemingly fine except, intermittently, it won't spin. If I fill the tup up again and run the wash or rinse cycle again it usually will start spinning again during the ...

...the pump. It is held on by three recessed torx screws ( I think T15 of T20) I had to push the tup to make it way off center so I could insert a 1/4 deep socket with a torx adaptor. This is a ...

...to the inside and bottom of your washer. You will see a drain filter between the bottom of your tup and the pump. Before you remove it you will need to hand bail the water out of your tub. Twist ...

...to adjust it. machine works, but bangs like crazy. There are 4 suspension rods that hang the outre tup from the top frame. One is the came off during the off balance load. Easy to put back ...

...have a shock ( similar to a car) arm starting from the base and angling upward where it meets the tup.Look for the seperation there and then let me know and I'll be happy to guide you through

kenmore washer tup wobbles easily Took it apart and found a broken spring.This one is longer and smaller than the 3 large springs still attached to the bottom of the tub.I can't seem to locate the ...