Dell 924 All-in-One InkJet Printer "paper try wont catch" Questions

...fit to the paper feeder. 3. Reload paper and try printing. If all of those steps above wont resolved that issue, your printer is needed to send to the nearest service center in your area. --->> ...

...paper up but it just wont 'catch' it and then the printer times out and the standby button flashes red. This has happened ever since I got new photo paper for it but it is exactly the same paper! i ...

...around with that. It might help to understand if you take the back off the printer and get a flash light and try to print a photo, you will see the paper tray slide in and see it feed. hope this ...

...the cartridges and load some paper. Try to print a document again to verify that the problem is fixed. If problem continues, please contact Lexmark Technical Support Center for additional

...try to catch on the paper level sensor tab and pulled it out of place. Since this was out of place when the printer lifted the paper, the printer did not know that the paper was up and would keep ...

...paper catch. Try to print the job one more time. If these steps resolved the issue , there is no need to continue troubleshooting. If the issue persists , see the next step. Step three: Choose the ...

...try and feed paper through, it gets snagged against a plastic thing at the back. i can see the obstruction, it looks like some sort of black spacer, possibly used for adjusting for paper thicknesses, ...

...paper, its a bit more expesnive but wont wear out your printer with jams and dust. Most folks (including myself) think the rollers are actuated when printing, actually the paper tray causes the ...

...wont load the paper when the feed rollers turn. the paper is too low for the feed rollers to catch.i put about 1/16 inch tape above the cork on the paper tray,but the rollers wont pick it up. i have ...

...try. My first attempt found it a bit too restrictive and feeded to sheets at a time but adjusted it once and its back to normal. I know its a bodge but its a cheap one and it uses a rubber band, just ...