Sharp (SHRAM900) All-In-One Laser Printer "fuser cause strips printing" Questions

...cause the fuser unit to overheat. To check for any stuck sheets of paper in the fuser unit: Locate the rear door and open it. The rear door opens and drops down towards you. Look into the back of the ...

...cause these problems Lack of toner or faulty toner cartridge.- shake cartridge and try again Defective fuser - replace fuser Contamination in the laser path -. 1.)Clean the laser path. (Remove the ...

...over to seal must use adhesives that are compatible with the heat and pressure of the printer fuser. the extra flaps and seals can cause wrinkling, creasing and feed jams, could even damage the

...cause a low amperage problem in your printer which can trigger a false fuser error. If this does not help or if this error appears every time the printer is powered on, you will probably need service ...

...tan colored lines or marks on it then the drum is worn and needs replaced. You can also check the Fuser unit. Take the paper that has the line on it & see if it matches to the fuser. It may be ...

...printing that just started. Cannot locate the source....... Could it be more like a clicking or grinding noise? That would be the swing plate assembly gears. Those gears connect the drive system to ...

...fuser cause this diagonal striping?? Thanks in Advance DRG hi, i had simular problem on a 3245 which is the copier version, fault was caused by the dev unit drive clutch sticking on and stripping the ...

Fuser err" . Would you please help me in this regard. [email protected] Hi nehu1, your problem exist with your line voltage: 1\ disconnect printer from any UPS , stablizer, additional power supply or

...printing now. You can also try to reseat the fuser and see if that works if you happen to have another printer the same you can swap fusers and see if they both work. here is what i got from an HP ...

...the fuser, not "melting" the toner to the page. There is one thing also, it is not recommended to plug any laser printer into a UPS or power strip as this can cause all kinds of wierd print