Galaxy Radios DX-959 40-Channels Base CB Radio "note 2 switch" Questions

Ad

Question about Ranger Radio Communications

1 Answer

Note - You must have an Armature License to legally perform this conversion. 1. Remove bottom cover from radio. 2. On the main PCB, locate J33. (See diagram above) 3. Locate wires on pins marked "P5"

Ad

Question about Galaxy Radios Radio Communications

1 Answer

...2. On the main PCB, locate J33. (See diagram above) 3. Locate wires on pins marked "P5" (yellow) & "P6" (grey). 4. Cut wire on "P5" (yellow) and install a SPST switch in line. 5. Cut wire on "P6" ...

Ad

Question about Connex Radio Communications

3 Answers

...ask for a radio check, see what happens. IMPORTANT NOTE: make sure the SWR on your anntena is below 2, and innitially use the radio on LOW RF Power. If you SWR is above 2 you WILL burn out the

Question about Radio Communications

2 Answers

...6. Key Mic again and note the actual measurement on the SWR scale. Refer to the following table to interpret the reading. 1:1 - 1.5 Great 1.5 - 2:1 OK 2:1 - 3:1 Not So Good Higher than 3.1:1 ...

Question about Galaxy Radios Radio Communications

1 Answer

...2 inch out. Place the srf/swr switch to swr. Go to channel 1 and note the SWR reading on the meter. Go to channel 40 and do the same. If channel 1 SWR is higher than channel 40, then screw the tuning ...

Question about Cobra Radio Communications

1 Answer

...2 ft wilson trucker antenna on pickup it has a good ground i ran new rg58au coax. when i try to calibrate it wont even reach the cal mark. when i use my external swr meter i cal to set mark when i ...

Question about Cobra Radio Communications

1 Answer

Switch 2. ANL - Automatic noise limiter. - This gets rid of electrical interference noise from the vehicle, or other interference sources. ANL/NB - This is the same as ANL, but with NB "noise blanker"

Question about Cobra Radio Communications

1 Answer

...2 is not so great, but not extremely bad, but you should try to get it lower. 3 is really bad. Anything past 3 is considered infinity, and is really really bad. If its high, then your antenna is ...

Question about Connex Radio Communications

3 Answers

...note what your reading is. Now leave the swr meter in ref and turn the cb to channel 1. Key up and take your reading. If the reading on ch 1 is higher than ch 40 you must raise the stinger on your ...

Question about Midland Radio Communications

1 Answer

...2 mag mount antenna cb antenna, obtaining power through a plug into the accessory outlet (connected correctly) and run a braided wire from metal under the dash to the radio for ground (continuity ...

Not finding what you are looking for?
Galaxy Radios DX-959 40-Channels Base CB Radio Logo

143 questions posted

Ask a Question

Usually answered in minutes!

Top Galaxy Radios Radio Communications Experts

eradiostore
eradiostore

Level 3 Expert

1672 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Galaxy Radios Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...