Transmission problem Took the agitator off and the agitator shaft pulled right out of the transmission! Had been having a problem with it not spinning on spincycle and getting a burn smell. Started by
transmission problem Having a transmission problem, washer only 5 years old washers do not have a transmission. Please repost with new symptoms
...then it could be transmission problems. BUT since the transmission is normally a sealed unit on the newer machines you will have to replace the entire transmission instead of just the high speed
Question about Amana Washing Machines
My Amana washer makes load noises during wash cycle, what could cause that? transmission bearings are the problem and transmission needs to be replace in order to fix the problem, in some cases some ...
...Kenmore / Whirlpool top load, direct drive washers use a "Motor Coupler" between the motor and transmission. It's used as a fail safe device and consists of three parts. Two of the parts are the ...
transmission could have either of these problems: Older washers produced by Whirlpool® have a transmission with an electro-mechanical shifter. If the shifter becomes even partially defective, the
kenmore 70 series --check the coupler it looks in tact. It will not spin.. Is it in the transmission? Pump is ok coupler ok but barely spins with lots of noise If the coupler is definitely intact then
...again appears fine. I did notice small amounts of a golden copper oil slightly dripping around the transmission. I am assuming this would be transmission fluid?? I dropped the transmission and found ...
.../ Whirlpool /Kitchen Aid top load uses a reversing motor to initiate the pump for draining and the transmission to spin. If the washer agitates fine, the pump will drain but the washer will not
1,252 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
680 Questions
658 Questions
476 Questions