Question about Maytag Neptune Washing Machines
...to replace both the power cord to the dryer and the terminal block inside the dryer that the wire is attached to. Ours did the same thing. Repairman said it was the "control main" for $500. Good
...power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy ...
...control panel itself. It is called "Schematic Mini-manual LED Washer" and it contains a set of schematics for the electrical system and an explanation on how to run various diagnostics on the washer. ...
power for control panel? If the control panel needs only one power source from Washer (110v), then what I have to do (fix) to have the power for the control panel? Right now my Dryer is in the garage,
Question about Washing Machines
...when I open door. Dry cycle ends, control panel lights and heat shut off, but dryer continues spinning. Only way it will stop is if I flip circuit breaker. Help! What happens when power comes back ...
...power and check on your control panel, it is possible that there is some faulty connection to the controller, check the wires to the sensors and the door switches. If not disconnect power for few ...
Question about Washing Machines
...power. 27. closed door. 28. started cycle and no operation. 29. rotated control knob full circle and no operation. 30. pressed every control on front panel with no results. 31. stopped cycle. 32. ask ...
Question about Kenmore Washing Machines
...has been running fine. Power to unit, control panel won't work at all. No owners manual to refer to. Kenmore elite dishwasher 665 15962990 Could be control board failure in which case it can't be ...
Question about Maytag Neptune Washing Machines
control locked red light is on so nothing I can do to power it up and use. I turned the breaker off and on but nothing happened. What can I do to fix this? If you are holding in Auto Dry Level for 3-4
...input power for 240 volts, then check the neutral power at all terminations inside the unit for burned off conditions, then check for a bad thermal fuse,hi-limit switch,start switch, or control ...
185 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions