DeLonghi EAM3500 Espresso Machine/Coffee Maker "blocked water spout" Questions

...water flows you may have a blocked line, bad pump, stuck solenoid or a bad generator. 2. Fill your tank and add descale solution. 3. Go to program settings - Descale. 4. Follow the prompts on the ...

...water flows you may have a blocked line, bad pump, stuck solenoid or a bad generator. Fill your tank and add descale solution. Go to program settings - Descale. Follow the prompts on the readout. ...

water spout is not blocked, as when removed you can blow through it. Hi sounds like a blocked boiler. Remove the water inlet line going into the boiler and use a 3mm drill bit and drill the inlet pipe

...blocked. I fixed it by removing the cover from the spout (see photo) it clips off with pressure applied to the sides on the dimpled part, then removing the brown reservoir inside after disconnecting ...

...blocked did you run some clean water ? The milk further is a different section from the coffee try and consentrat on the coffee part run some clean water is there any noise is the water going in to ...

...blocked. Or there is just a bluild up of coffee in the bottom of the handle. Either way you should clean all of these parts. Remove the filter from the handle and poke the spouts. Then soak them both ...

...water spout is not dispensing water properly. The flow rate is low. its not the spout itself, I've replaced it... The water line appears to be unobstructed... Any idea what could be blocking the line ...

...water in the tray though. Mike You can either try pulling the spout down several times as you run the rinse cycle, and in essence banging out coffee grounds that may be partially blocking the flow of ...

...water pathway from the tank to the brew unit may be blocked with scale or debris. Try running a cleaning solution through the machine to clear the pathway. Brew unit: If the above solutions do not ...

...ground coffee. It pumps a full shot of water through the wand but makes no coffee. May be blocked or foulty selector or bad commands from cotroll PCB try running descaleing may be spouts are ...