Question about Kenmore Washing Machines
water supply system to eliminate this. Need to contact a plumber if you want to eliminate the banging. Don't know why this would affect hot water pressure -- maybe that's another problem? Charlie This
Question about Maytag Washing Machines
...water feeds to your washer - and disconnect from the machine. Open each valve one at a time into a sink or bucket until air is purged. Reconnect hoses, and re-try. This is called AIR HAMMER and if ...
...eliminate vibration? Is vibration caused because the solinoid on the dishwasher is going bad? these vibration in water pipes or cooper lines come from air in thewater supply system..dont take your ...
Question about Fisher and Paykel Washing Machines
...water hammer". This occurs when the water valve solenoids shut off quickly, causing the pipes to physically jump from the rapid buildup of pressure. There are two solutions. First, secure the water ...
...water suddenly stopping can cause the pipes to rattle or bang. Adding an air chamber would cusion that, and eliminate the banging. I have seen some (at a local Home Depot) which can screw onto the ...
eliminate the problem by setting the water temp. to anything other than warm/warm. It pulsates enough to cause the supply hot water pipe supply to hammer. I suspect that the water control valve it the
...water until it hits the agitate (wash) cycle will not go into spin or rinse. Buzzes only (no action from washer) in the spin cycle. The timer would not start when pulled a couple of weeks ago but has ...
...water only. I believe this is our only ($800) solution. Anybody else have an idea? We had the same smell. It was so bad you could smell it when you came into the house. We switched to powdered ...
Question about Fisher Washing Machines
...eliminate the air dome hose as a problem. Look for signs of cracks or worn areas on the hose. Remove the hose and submerge in water. Seal one end and blow air into the other end and look for bubbles. ...
Question about Fisher Washing Machines
...eliminate the risk of getting water in the electronics. You need to remove the rotor next, it's the plastic rotating component of the 3 phase motor, there is a plastic nut in the middle, remove this ...
37 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions