washer will not go into high speed spin ohm motor 1.7. should be 2-3 ohms so I changed mot and control board. Still have same problem. Model #MAH20 commercial front load washer could be door switch if
Question about Maytag Neptune Washing Machines
...valve stem. I need to change out my water supply valves. This would be good time to clean out your supply water inlet screens in the washer water inlet valve assembly. Check for a hose leak at washer ...
Question about Maytag Neptune Washing Machines
change the "intensity" (regular, medium, delicate, air dry) before I start, then it dries better. Just flipping between settings a couple of times. Any thoughts? Mj, 90% of the time long dry times are
Question about Maytag Neptune Washing Machines
model # mah6500aww: makes banging noise and causes machine to move when I star the cycle, it makes banging noise. The banging is so strong that it causes machine to move physically . I had to stop the
Question about Maytag Neptune Washing Machines
...valve, at top where water enters machine. Power off the mains, see if the wires are connected tight. If they are ok and you still have the problem, you simply have to change it, yourself, by taking ...
Question about Washing Machines
...change the inlet valve. It depends on the model on how hard it is to change. The water level switch has no adjustment on it. it would need changed if it is acting up. Get me a model # and I can get ...
valve is OK or not? What brand and model do you have, most domestic units have a combination hot/cold valve? You just need a meter too verify the valve is closing, if the valve solenoid is closing you
Question about Fisher and Paykel Washing Machines
...change your water valve?Did you remove any wires from the controller when you changed the valve?Have you checked for power at the power point with a small appliance such as a toaster ?Is the water ...
...day, This tutorial doesn't address the water valve directly but it does get you to the area you need to change the valve. Use only the part you need. ...
...model number, it will bring up diagrams and parts. You need the water inlet valve or supply valve. It's not hard to change out. If you can dop it yourself, it will save you around $100.00. Good ...
80 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions