...water fill cycle. With most cycles the depth of water is around 3.5 inches in the wash basket. I know a Bulky Wash cycle selection will fill the wash tub to a high fill which is about 7.5 inches of ...
Question about Maytag Neptune Washing Machines
...fill up cold water properly, just drip. I need to turn on the tap for the tub for a few second, then it properly fill. After one cycle, it happen again. Is it something wrong with the water ...
Question about Maytag Neptune Washing Machines
Water leaks from the door until the waterline is below the lower lip. if you unplug the machine does it still fill? If it does then the fill valve is bad. happens alot when machines are on well water
...water fill which is only 7 inches or so of water in the wash basket. 3.5 inches of water for a medium fill. You can turn on/open the water inlet valves in Service Mode but I would not recommend that. ...
...water valve at the supply and do a hot fill....leave the Hot water supply valve open? Do you hear water filling the wash tub or do you error out with a NF error code for no fill?............. ...
my washer won't stop filling with water i changed out the water valve and still have the same problem. even when the washer goes in to a drain cycle it still fills with water.... thanks for your help ...
Question about Maytag Neptune Washing Machines
...fill with water when the start button is pushed. Have you checked the water pump? I would say it is that or the button may be defective. Hi, If your washing machine will not fill, only hot or cold ...
...fill. You need to, first, make sure the water supply is turned on. Second, if the water IS turned on, and you're still not getting anything to your washer, you may have a fill valve problem. The fill ...
...water fill error. The Control Board has not sensed from the pressure switch the correct water fill level after X amount of time. Do you hear water flowing into the washer for the Cold or Hot water ...
Question about Maytag Neptune Washing Machines
...should be well Shut off the water supply vales on the wall. You could have a bad water fill valve or a bad water level sensor. I hope this helps. If I can do anything else to help please let me
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions