Question about Maytag Neptune Washing Machines
if it still doesn't run you need the main board and the motor/ motor control kit. If it has the newer motor, you would also need to test and replace the motor and/ or the motor control board separetly
Question about Maytag Neptune Washing Machines
motor control board and a new motor. I also replaced the main circuit board, however, the machine fills with water, but when it comes time for the motor to actuate, the on light goes off. A few months
motor control board. My question is can I just replace the fuse or do I have to replace the entire board? Obviously something caused the fuse to blow and I was wondering if this could have been caused
...surge blows the R11 resistor on the board, requiring you to replace the wax motor and an expensive board. Major enginering error by maytag. The board costs around $240 and the wax motor is around ...
Question about Maytag Neptune Washing Machines
...replace the motor. It sounds like your motor is fine though. The most common cause of failure in these motor control boards is electrical surge. Many control boards now have built in surge protection ...
...diagnostic test. 2.Check motor control board for damaged components. 3.Check wire connections in harness leading from machine control board to motor control board. 4.Replace responsible
Question about Maytag Neptune Washing Machines
...replace the motor control board and motor if you have the original one as Maytag has redesigned these two components due to reliability issues. The new motor conversion kit is part # 12002039. If ...
Question about Maytag Neptune Washing Machines
motor and board, as the original pcontrol board is discontinued I have been able to buy a used control board of exactly the same specs as the original one from an old washing machine. Before I install
Question about Maytag Neptune Washing Machines
...motor control board on the bottom are OK.The problem will be in the main control board in the top consol.board should then be replaced.If tub is not moving at all it could be the motor control board ...
...replace board? Did problem resurface after replacing board? Would a replacement board have the newest version of software? A 3E error is an overcurrent detection at the motor. Some people say that ...
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions