...inlet screens. Use a thin knife blade or a scribe on the outside of the screens and remove them. Wash them under slowly running water while rubbing them with your fingers to clean them off. After ...
Washer is stuck at 45 minues I was trying to do a load of whites and when the cycle got down to 45 minues left it got stuck and wouldn't continue the cycle. Check the inlet screen on the cold water ...
inlet valve screens. How do I remove my neptunes inlet valve screens so the water can flow into the washer to wash and rinse the clothes? There are two blue hose connectors on the machine and I am not
Question about Maytag Neptune Washing Machines
...inlet before it gets to the dispenser and watch for leaking. the valve is a sealed unit but can sometimes be fixed by removing and soaking in a lime remover, drying and reinstalling. I am a repair ...
Question about Maytag Neptune Washing Machines
the water does not flow to the softener reservoir of my maytag neptune tl. most likely problem is to low of cold water pressure. if you set it to cold/cold, and the water coming in doesn't have much ...
...inlet valve by removing the fill hoses to the washer and looking with a flash light. There should be no rust, sand, or water deposit on them at all. If there is remove it and test the machine. If ...
...screens you can clean are located in the throat of the water inlet valve which can be acess from removing the water hoses, dont know where or what screens you could possibly get to be lifting hte ...
...screens inside the water inlet valve. Make sure they are clear of rust and debris. The solenoids can be checked using a multimeter or ohmmeter. Test for continuity. A lack of continuity indicates a ...
clogged inlet screen nf what do I do The inlet screen is removable. It may be attached to a rubber washer. If you can remove it, then rinse it out and reinstall it. rohl521 has you going in the right ...
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions