...240v power terminal all ok. Display pannel does not light up all seems dead. Is there an overload or fuse somewhere. Cheers Fred Schaefer I replaced the controll board and the motor trigger ...
...motor is faulty. if a noise then there may be a bra wire between the drum/tub. On my atlantis maytag, the lid has a trigger in the middle that starts the machine going. The lid has to be screwed ...
Question about Fisher Washing Machines
...power point but it still will not work just beeps and nothing else. Please help if you can, willing to try anything. Thanks I can help with this. I work on the units they make. If you can email me @ ...
Question about Washing Machines
...power surge that is triggering the GFCI. Another possibility is that there could be a short circuit in one of the components of the burner, such as the ignition module or the solenoid valve, which is ...
...power cord for ten minutes. Try also keeping start button pressed for ten seconds. If this does not work there may be a problem with the control timer. I will post the meaning of f11 in detail. F11 ...
motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect. The faults mentioned indicate that the control panel is not working and so it
Question about Fisher and Paykel Washing Machines
motor controller or your rotor position sensor.Please try the joining of the wires and see how you go.If it rectifies the fault then change the switch, if it does not rectify the fault then I can help
Question about Maytag Washing Machines
...power terminals and clip one probe of the VOM to each terminal. The meter should read about 12. (1200) ohms. If the reading is higher ohms, the heater is faulty and should be replaced. Replace a ...
Question about Washing Machines
power from the appliance and then locate the correct timer contacts as noted on the wiring diagram. On some electronic controlled models, the start switch is a momentary contact type switch located on
...power source for about 2 hours, replug and try again. Should that not work, try these: 1. Make sure you do not overload the machine 2. Check for any debris/lint/coins, etc that may be blocking the ...
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions