...washing machine and it started making a loud noise when on the spin cycle. Is this a bearing problem, belt problem. thanks for any suggestions. Bearings do exist but need a special puller to remove. ...
do i need a 'puller' to replace washer bearings? neptune front loader.. Look at the TONYTOOL video. You can also get the replacement bearings, seal and rent the tool on the net.
Question about Maytag Neptune Washing Machines
...bearing! Bearings do exist but need a special puller to remove. If techs i n your area have it part numbers are 22002934 , 22003441 also needed is spacer 22002935 and seal kit 12002022 or else you ...
Question about Maytag Neptune Washing Machines
...bearing cost about $400 if I remember correctly. If you look on ebay or other internet sites there are guys out there that will sell the bearings and a home made puller. I had a little bit of trouble ...
...machine, Remove rear access plate Carefully slide belt off of large pulley as you slowly rotate pulley Remove large pulley bolt (9/16" ratchet) and pull pulley Use a large rubber hammer and carefully ...
...bearing WM1832CW LG washer to replace the rear bearings do you use a puller to remove the metal housing from the drum shaft You can try a puller but typically it is recommended to replace the entire ...
Question about Maytag Neptune Washing Machines
...washing machine It is a difficult job in terms of handling! You require spanners and bearing puller. You require one extra assistance to hold the drum and pull from the front. You have to change the ...
Question about Maytag Washing Machines
...the drive spider and/or tub or scrap the machine. Link below will give you an idea of what is available from just one manufacturer... ...
...washing machine. The machine is especially loud toward the end of the wash. How much would this cost to repair ? You have a damaged bearing and seal. I strongly recommend a trained technician to ...
230 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
151 Questions