...gas flow to the burner. Solenoid makes a loud noise for about 5 seconds while ignitor glows, then cycles every 30 seconds. I disconnected the leads to the 2 solenoids and checked for voltage. The ...
gas, nor does it light. The grinding noise was loud enough to hear through a closed door- not a usual noise. Assume the 'click' was the flame sensor closing. Is the grinding noise something to do with
...gas dryer from heating: - glow bar igniter, thermal fuse ( not all models ), coils on the gas valve, gas valve, thermostats, motor heat switch, timer, selector switch, sensor. Please do rate the ...
...gas dryer (110-92832100) not heating. Igniter glows red for a min or so, drum spins, hear a loud 'buzzing' noise.... The problem could be flame radiant sensor or in most cases the gas valve ...
glow bar starts to light but nothing else happens, you eed to check the heat sensor. It is connected to the flame baffle at the end of the gas valve. It will have 2 wires on it. One white and one blue
Gas valve coils Watch the igniter. Does it glow bright orange, then shut off without igniting the gas? (When the gas ignites there's a large blue flame.) If so, there may be defective coils on the gas
gas dryer, be careful not to drip oil anywhere near your glow plug / ignitor. We were having the same problems with our dryer except we were able to find what it is. turns out it was a bad belt in the
...glow plug (this ingnites the gas). This happens several times during a cycle because the dryer is programmed to turn the gas off and back on to maintain a constant heat during the cycle while ...
2,008 questions posted
Usually answered in minutes!
867 Questions
815 Questions
489 Questions
196 Questions
146 Questions