remove the cam from the bar, glue it back together, then wrapped it tight with thread (only one layer, there is a clearance issue), and put epoxy around the thread(to help reinforce the cam). Once the
Question about Kodak EasyShare Office Equipment & Supplies
...remove the inner workings from the casing. A few screws and plastic clips to release but not too bad. The trick comes in when you have to release the slide bar that runs through the carriage. It is ...
Question about Dell Office Equipment & Supplies
...front. The bottom should be facing you, and the back of the unit should be pointing towards the ceiling. I will use this orientation when describing the following steps. Most of the back of the ...
Question about Dell Office Equipment & Supplies
...front. The bottom should be facing you, and the back of the unit should be pointing towards the ceiling. I will use this orientation when describing the following steps. Most of the back of the ...
...Remove the ribbon tray and set it aside and look at the forward receiver that the front part of the ribbon tray would rest in. Trace a descending line with your eye from the ribbon sensor to the ...
...front. The bottom should be facing you, and the back of the unit should be pointing towards the ceiling. I will use this orientation when describing the following steps. Most of the back of the ...
63 questions posted
Usually answered in minutes!
1,024 Questions
996 Questions
812 Questions
74 Questions
69 Questions