Lexmark E240n Laser Printer "bent" Questions

...printer would not properly pick up paper, & the jam light came on almost immediately (The paper was bent into a horseshoe, but did not pass the first roller) I found no stray paper anywhere in the ...

...through rollers. Rollers are turning and nothing seems to be lodged in printer. The case is not bent in any way. It's a plastic case and you can't see without removing covers. If it's been packed ...

paper goes in bent in printer so printed item is bent Dear jabir, Please check if any other material is present in paper path from paper tray to platen unit (paper eject assembly). It's usually caused

staples are bent in a wrong way when i turn on the finisher, staples are bent in a wrong way. What i can do ? Replace the stapler

...from it it says that it's open... Ckh cassette present switch as shown in fig.. switch broken, bent, misplaced as well as cassette switch trigger broken or

...resistance checks were good and the thermistors were replaced. Fuser module PJ 700 pins were not bent. The inboard Plug 700A is mounted in a metal plate that was bent, not allowing Plug and Jack

Paper doesn't feed right most of the time. The lower right corner of the page gets bent on the way through the printer. I frequently see a lot of ink where the page gets bent up also. Can this problem

bent cf pins on snaplab Unbend pins by using a hypodermic syringe - the type vets use for horses. The needle will fit over the bent pin and allow you to put it back where it ought to be. Your local ...

The big black cartridge got stuck and when we got it out the printer had a bent wire but then the bent wire broke out. The cartridges were not being read as long as the big black cartridge was in but ...

...it is securely closed If you pull the fuser out, look at the bottom of the sliding mechanism for a bent metal tab that actuates a switch when you close the rear drawer. They get bent pretty