Maytag MER5530 Electric Kitchen Range "oven reads f1 2" Questions

...f1-2 error when using top oven or bottom oven. would this mean the lower over temp sensor needs to be replaced? Check the sensor for correct ohm reading. If it is good, replace the control. It should ...

...F1 EOC (Electronic Oven Control) failure Replace F2Oven too hot Check Bake function F3Oven temperature sensor openCheck oven temperature sensor, 1100 ohms F4Oven temperature sensor shortedReplace ...

...Oven Fault Codes F0, F1, F7 Stuck keypad may mean relay is turned on. - Determine if problem is with the Key Panel or Control by: 1. Pushing CLEAR/OFF pad. 2. Disconnecting Ribbon Cable from control ...

f1 on the read out comes up and the oven well knot work it keeps comeing up f1 on read out it is a maytag rang mer5770aab sel.no.13196174uu Hi martysherrip, The F1 fault code description is a ...

...reads F1 Here is some wisdom for understanding F1 fault codes. In some models, there are subcodes that make diagnosis even easier. Here's a simple explanation of what's going on and how to ...

oven cleaning, F1 code appeared, oven beps but does not work, stove top does work, after turning off and on, code dissapears but beeping continues Maytag MER5730 On ranges where the electronic control

...F1. Since then the oven has not worked properly. The broiler works and I was able to set the oven at 500 and that got the temp to 300. Now I can't do that. Any help would be greatly appreciated. ...

...oven, door lock light remains on , disconnected door switch, stays beeps with a F1 code, I assume the door lock switch is bad but until I replace it , how do I stop the beeping F1, Thanks. Sorry to ...

...oven sensor has to be within spec or it will cause the F1 code. As an example of being out-of-spec, the ERC will generate an F1 fault code when the sensor shows 1650 ohms during a time-of-day mode. ...

...F1 fault code and the problem was the oven temp sensor - check carefully the wires to and from the oven temp sensor!! This has been a new occurrence to us in the last 2-3 years or so Thanks for using ...