Maytag MSD2756GES Side by Side Refrigerator "remove light wiring harness" Questions

...Remove that, and you should be able to slide the mesh sleeve off, over the plug. This should reveal the broken wires. I just took some 12 gauge braided wire and cut a couple of pieces Manufacturer ...

...light fixture in the control bracket. Removing the Dispenser Assembly 1. Do the previous three procedures. 2. Remove the eight (8) hex-head screws securing the dispenser housing to the freezer door. ...

light won't work ouch!!!, heres what i wouldlook for, foirst off remove the lower kickplate, from ther youll see a wire harness leading from the bottom of the door leading to a multi plug right in the

...light that goes on when you use the water dispenser is not functioning. Bought 2 replacement bulbs from a parts store for this model, but they aren't working. I suspect a short somewhere but don't ...

remove the old switch? Light bulbs are ok Just remove the top panel (the one you open when you vacuum the condenser/compressor area) and you will see the top of the switchplates. They are very easy to

...light is gone. The bulb is ok. When I remove the bulb, the digital indicator is OK. After I put the bulb on, the numbers from the digital indicator is gone. The door switch seems ok. The cooling ...

...light bulb is good on out side but its not working either, its like no power is getting to the outside water/ice part. Help!! At the top left hinge there shuld be a cover over the hinge. Remove that ...

...it in a plastic box,remove the screws that secure the box and then remove plastic top cover and there will be 3 wiring harnesses,unplug them,replace the control board and reverse procedure to ...

...light working at the dispenser either. The problem is very likely to be the wiring harness, located under the freezer door, goes behind the toe plate, so remove that for easy access. you will see a ...

...light does not go out and the water in door does not work then the door switch has failed. The door switch is released from the cabinet by sliding either a putty knife or a knife blade along one side ...