Hitachi Deskstar 7K500 500 GB Hard Drive "drive jumper sata" Questions

...SATA 3.0 ! It should be backwards compatable but it might be that you have to switch a jumper. instructions for this should have come with the hardrive itself but if not check this out ...

...drive and the settings for plastic jumper location is usually printed on the top of a hard drive IDE-0 means Pri master IDE-1 means Pri slave IDE-2 means Sec master IDE-3 means Sec slave single or ...

...slave　 :::': note the plastic jumper is ' located at the rear of the hard drive next to the IDE/SATA lead/s hope this helps dont forget to ...

...jumper, is it on the right place? besides, some motherboard is indeed do not support hard drive with large size on it... Chances are you are using original XP pro disk. You need to install using SP1 ...

...advance for your support. Best Regards, Stéphane PATA drives have the jumper settings printed on the label. With SATA drives there is no master and slave. Just select boot device in the

...slave　 :::': note the plastic jumper is ' located at the rear of the hard drive next to the IDE/SATA lead/s hope this helps

...drive 0 or do I need to do something? there are few thing you ahve to keep in mind there are two type of hard disk 1. IDE 2. SATA As per your hdd capacity it should of IDE type. Now there are two IDE ...

SATA HD to a system whose C and D drives are a WD 400GB PATA HD. The Hitachi 750GB drive has no jumpers for master/slave. After boot-up the system sees it but assigns no E or other letter designation.

...jumper is ' located at the rear of the hard drive next to the IDE/SATA lead/s 　　　　　　 ...