flame sensor is a metal rod that is on the opposite side of the ignitor. To clean the flame sensor you will need some steel wool, turn off power to the furnace and remove the flame sensor and clean it
...flame sensor needs cleaned. On the opposite side of red glow is a small steel rod with a single wire going to it. Remove this steel rod and clean it with a piece of fine sand paper and re-install it. ...
Question about Heating & Cooling
...is a small rod that protrudes in to the flame as well. If so it is part of this flame proving cycle. Take some sand cloth and clean it. This may buy some time but the rod should soon bee
Question about Ruud Heating & Cooling
...flame sensing rod might need to be cleaned. If the pilot wavers off of the sensing rod it could cut off the heating cycle because the system could not verify a flame yo bring on the main gas valve to ...
...flame rod issue or the flame is not getting to it in time. The flame rod is located either far right or far left in the burner box and has only one wire going to it. It should be in line with the ...
...a piece of sand paper or steel wool and clean the flame rod sensor but be careful because the end of the flame sensor is porcelin and breaks easily. If this help please rate me and do a
...flame sensor you will need some steel wool, turn off power to the furnace and remove the flame sensor and clean it with the steel wool. After cleaning reinstall it and turn power back on to
flame there". A fine grit sandpaper works well to restore it's conductive ability. However, if the furnace runs for a while before it shuts off you could very well have an obstruction in the vent pipe
...side of the igniter, turn off power to the furnace and remove flame sensor, take some steel wool and try cleaning the flame sensor after cleaning reinstall it and turn back power to the
Question about Weather King Heating & Cooling
...flame sensor is a metal rod located on the opposite side of the igniter that senses the burner flame and will keep the Furnace running, what happens is the rod builds up oxidation and then cannot ...
56 questions posted
Usually answered in minutes!
713 Questions
254 Questions
136 Questions
135 Questions
72 Questions