Question about Whirlpool duet Washing Machines
...add a garment and wash light are on but when I try to start it nothing happens its a washing machine built be a man so its none to smart you have confused it to much by asking it twice to do the same ...
Question about Whirlpool duet Washing Machines
...ADD A GARMENT. WASHER WILL NOT START NOW. I HAVE EVEN TRIED TURNING IT OFF, BUT THE LIGHT STAYS LIT, AND THE WASHER WON'T START. have you turned off the power and unplugged the unit for 5 mins? plug ...
...add the garment light is always on. The pause/cancel button is always on, even if you try unlocking the door, the light comes on, plus a couple of minutes later, the machine turns off, leaving just ...
...add a garment light is still on, the door is shut tight and the time remaining in the cycle is flashing. It will not even turn off. Press and hold "end of cycle" button for 3 seconds, on the right ...
...Add a Garment" light is lit on the Duet's display. The light will only be on during the first eight minutes of a washer cycle, when the function is usable. Press the "Pause/Cancel" button once to ...
Question about Whirlpool duet Washing Machines
...Turn the power back on and press the cancel button twice and make sure the washer is set to spin and drain cycle and run and watch it off and on until its done. 13. Go ahead and put the lower panel ...
...turn on. Kenmore He2+ washer will not work. It finished a load and buzzed but door would not open. Tried the 2 presses of stop and three presses with a 15 second hold. I found instructions for manual ...
...turn off the rinse to remove excess water. Is the door locked and the Add A Garment light on? If the Add A Garment light is on, then the washer door will unlock after the Pause/Cancel button is ...
Question about Amana Washing Machines
turn it on and set the cycle to normal it just beeps and says to add garment and when I go to open the door it's locked so I have to push power of f probly micro switches on struts ie shocks Never try
...turn it on, the door won't unlock. I can select a cycle but when I press the start button it won't go. Any ideas on what could be the problem? Similar problem here - pump was set for a 58 ...
94 questions posted
Usually answered in minutes!
9,125 Questions
187 Questions
64 Questions
34 Questions