...Kenmore Elite, there is now a "cleaning cycle" function on the timer to accommodate this feature. Now...if you try these steps and you still have an odor problem, try checking the drain trap for ...
...Remove the dispenser cup and soak in some hot water to dissolve all residue. While you have the dispenser removed check under the dispenser cap in the agitator for gummy residue as well. Clean with ...
Remove the dispensing tray and take it to the sink. On the under side of the tray are molded in caps that fit over tubes at the washer. Clean the caps out well. A Q tip works well for this. Also clean
...Kenmore washer I need to replace the dog ears in the agitator but can't figure out how to remove that assembly which is over the bolt. See parts blowup at following link: ...
Kenmore: Remove the agitator center cap by either pulling straight up or gently placing a flat blade screwdriver into a slot located in the cap. Sometimes this is a dispenser cup that simply pops off.
Question about Whirlpool duet Washing Machines
Kenmore HE2 Frontload Washer will Not go into spin cycle After the wash cycle and going into the rinse cycle, the washer stops and just flashes. Putting it on rinse and spin does not seem to work ...
...Kenmore Stacked Washer has gunk in the middle of the agitator under the cup that dispenses the fabric softener. How does the fabric softener dispense? Does it spin out the top, or does water come up ...
...remove agitator cup to replace dogears on a kenmore elite washing machine This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump ...
Kenmore 24622300 My washer will not run with clothes in it. If I empty it out, unplug it and wait 10 minutes, it runs just fine empty. I'm assuming there is some sort of mechanism in the agitator that
Question about Kenmore Washing Machines
...remove the agitator. I have the fabric softener cup removed and i can see the splines but they only grab going one way. i cant figure out how to take it apart because there is no screw holding the ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions