...wash cycle, do you get hot water? If you only get cold water replace the hot water fill valve. If you only get hot water replace the cold water fill valve. If you get neither replace both fill
Question about Whirlpool duet Washing Machines
...a hot cycle and check water at filling to see if it was cold or hot, if your unit has a heater make sure you dont select sanitize or very hot. then post correct model and heater info. to advise ...
Question about Whirlpool duet Washing Machines
hot water not being hooked up. Newer washers sense and control the incoming water temperature. If you select cold wash and cold rinse you may think that it will not ask for hot water so you don't need
...HOT WATER WHEN SELECTING EITHER HOT,WARM OR COLD WASH TEMPERATURES. WATER SOURCE FROM HOUSE APPEARS TO BE OKAY. I DO HAVE A TAKAGI TANKLESS WATER HEATER, WOULD THIS HAVE ANY AFFECT ON THE TEMP? WHAT ...
Question about Whirlpool duet Washing Machines
Hot water rinse when cold rinse is selected Washer will only rinse with hot water no matter the setting. It will wash with cold water so I know the cold side works. First off make sure your hoses in ...
...water to the hot select hot wash and see if the water flows into the machine That error is a temperature sensor error when the unit heats the water during the wash cycle visit the link below for ...
...hot water. OK, maybe more than occasional. Like, I hope you at least wash your skivvies in hot water. 4. Leaving clothes in the washer at the end of the cycle. Front loaders don't have as much access ...
...the timer. That is an expensive repair 100-150. Make sure the water is on. Try selecting hot and then try cold. If one works and the other does not then it may be a valve which will be about
Question about Whirlpool duet Washing Machines
...a machine that has a seperate temperature thermostat which you can manually set to low if you wanted.or a top laoder that has a hot and cold water inlet. You could just connect the cold water
Question about Whirlpool duet Washing Machines
hot? The water inlet valve on the back where the hoses connect to the washer is not working or is stuck closed. You can swap the wires with the other (hot) valve and see it the cold will work when you
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions