...remove water pump from motor shaft. The motor and pump are removed from the machine and the three torq screws are also removed. your pump been leaking water and has the pump rusted to it ,,,,, if the ...
...remove water and take off hoses.pump is secured by 2 phillips screws underneath.remove wiring block and after removing pump there is three t15 tox screws on pump housing. sounds like u have something ...
Question about Washing Machines
wft802 drain error have removed pump and cleared worked for one wash now doing the same have removed pump no blockage should i get new pump or could it be some thing else removed pump found blockage ...
...pump area -remove drain hose to pump by looseing clamp and pulling off. -remove hose to tub by losseing clamp and pulling off. -remove power connection at back left of pump. -unscrew two philips ...
...pump assembly counterclockwise and remove it from the base of the washer. Remove the plastic bag covering the pressure switch. Press in the locking tabs on the back of the pressure switch and pivot ...
Question about Frigidaire Washing Machines
...pump. Now remove as much water,now make Sure the machine is unplug. Get lots of towels , removed the two screws that holds the pump. Place towels under pump, caution water. Slowly unscrew the drain, ...
Question about Fisher and Paykel Washing Machines
...pump. To remove pump: disconnect wiring plug connection + earth wire. At the top of pump there is a white plastic tag- lift up and turn pump anti-clockwise to remove. Note- water will come out when ...
Remove the pump filter from the pump housing and check it for any obstruction. Check the sump and drain hoses for any obstruction. Remove the drain pump from the housing and check the impeller for any
...pump. Remove the top lid from the washer. Then remove the front panel to access the water pump. The pump is attached to the front of the motor. Remove the pump support clips then remove the pump from ...
...wall. depress plastic tab in base to release pump. remove hoses and unplug electrical connection to pump. remove 3 screws holding pump motor to pump housing. install new pump motor and
40 questions posted
Usually answered in minutes!
196 Questions
158 Questions
47 Questions
55 Questions
45 Questions