Asko 24 in. 1585 Built-in Dishwasher "bottom wash arm hits" Questions

...bottom rack is clean..we tried cleaning filter and making sure the wash arm wasnt hitting anything..we tried different wash settings..please help Jessie Oakes Check that the top rotating arm jets are ...

...And check that wash arm carefully.... Might it be split or bent? Are the holes on the bottom clear? (Those holes are usually angled to push the arm around; if they are clogged, the arm won't

...wash your dinner plates in there, from tray to arm is 250cm. on the topshelf of the dishwasher there are 2 lots of slide wheels . these are to set the shelf at different heights they should be on the ...

bottom sprayer and what do you gthink it could be? Is start up after filling with water? After it fills the wash motor starts to work. Some times the spray arm could hit the heating coil when it turns

bottom wash arm and arm only shoots little out spray hole and turns slightly than stop as pump seems to lack water and than repeats this over and over again which would to me explain the poor cleaning

...water cant get to the upper wash arm. That tube can be seen by pulling out upper rack and looking up at the bottom of rack, its usually grey and has a funnel on the back of it. I hope this helps, ...

...wash arm to spray against the bottom of the door, especially at the center of the door bottom, the resulting splash inside the door allows water to hit the outer door panel and drip out a one or both ...

bottom. Is the motor bad possibly? Remove the panel at the base of unit below door you should find the tech sheet which will tell you how to place unit into diagnostic, on the spray arms make sure the

...bottom rack. We have noticed the dishes are not cleaning well. Does that arm need to snap down? [email protected] Your best bet would be to get a wash arm rebuild kit from an appliance parts ...

...bottom blade"? Do you mean the lower wash arm? There is no "adjustment" built into the dishwasher, but if it's hitting the heater element (or its supports), you might be able to bend it slightly. If ...