...is usually where the belt is that connects from the motor to the spindle right at the front be careful when you remove it and when your putting on the new one watch your fingers the belts are ...
...Remove the belt altogether. Grab the end of the motor spindle, and give it a little wobble. While it should be free to turn, you shouldn't expect to be able to move it along its axis by more than a ...
...Watch for small controll knobs if there are any on your machine, they will pop off and run away if you don't heard them up now.) With the cover removed from the machine, roll it back over upright ...
...Watch the videos. The burning smell is the belt slipping on the drive spindle. This is caused by the brush roller not spinning freely. There is normally hair between the end cap and the centre rod ...
...spindle and the beater bar. I also noticed that the beater bar was quite shiny. I used some rubbing alcohol on the belt to remove some of the debris on it and then used a sanding block on the drive ...
remove the old stretched or broken belt. Then you slip the new belt over the spindle on the end of the motor and then over the end of the brush. Put the end of the brush back into its seating and then
12 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions
