Digital Blue QX5 Microscope "not plugged" Questions

...not plugged in yet microscope was plugged in before program was put on the computer. now it say your microscope is not plugged in. file the plugged in area gently then connect it.it may be workouut ...

...puck gently tap new plug into the block til flush with all edges of the plug to block . be careful not to install the plug at an angle or it will blow back out after engine heats up to normal ...

...and the misfiring will get worse. ONE will act differently from all the rest - engine speed should NOT change significantly for that one wire, and the missing shouldn't change much. That wire leads ...

...not plugged in. Does this device run from USB power.. (no plug in power supply) if so, the problem may just be that this device (not limited to microscopes) is trying to draw too much power, as not ...

whAT HAPPENS IF I plug a 110 volt machine to a 220 outlet Normally the plug connector would not fit, they are different.  But for some reason, if you have one that takes 110 and you plug it into ...

Your microscope is not plugged in, please plug in your microscope (105) or (102) driver?

...not responding My Qx5 Microscope is plugged into the USB and has installed the software, but no matter which USB port i plug it into it will not respond. The light activate, the image will not show, ...

Off/on light is flashing on HT handheld control and nothing is working on fisher plow but the headlights plow moter stays running joystick controller is saying its not connected to plow valves or pump

...plugged into with another device. Just because the bulb "looks good" does NOT mean it IS good, also. If the electrical source ("the plug") is "hot", then the likely culprit is the bulb. Next would be ...

not plugged in, quit and restart the program. If the program hangs or crashes, reboot the computer, then restart the program. ------------ Comments and suggestions to mmehall [at] yahoo.com ----------