Question about Compaq Computers & Internet
...jbat jumper bios will not clear it starts whitout jbat jumper an batterie and it still will ask for poweron password i want to remove the password but nothing works and it only asks for pasword and i ...
what is the JCI 2 pin jumper & the JBAT 3 pin jumper which is currently jumped pin 1 BIOS reset, you jump the other 2 pins to reset.
Question about Gateway Computers & Internet
...jumper setting that says 'jbat' move it to 2-3 sttings for a while then back again to 1-2. This information is intended for experienced users. It is not intended for basic users, hackers, or computer ...
...JBAT jumper located on the board. Its a 3 pin jumper currently set to 1 and 2,,, set it to 2 and 4 wait a few then set it back to 1 and 2. If you cant find the jumper or that fails then Locate the ...
Question about Intel Computers & Internet
...JBAT reset jumper from pin position 1-2 to 2-3 ... right? Furthermore, you did this of course to reset a forgotten/lost password ... right? If so, don't get out the panic button, you simply forgot to ...
Question about Intel Computers & Internet
...jumper either marked JBat 1, clrclk, clrcmos or similar and try again. If neither your old memory or new no longer allows the pc to boot, i would say that the motherboard has been stressed when you ...
...jumper near the cmos battery usually shows the word (jbat) near it , try to change its position for some seconds while power is off , this way will clear cmos and set the mainboard bios to default ...
Question about Dell Computers & Internet
JBAT jumper across pins 2-3 and then back to 1-2, this should then make you set up the bios again just incase there is a checksum error causing it. Also your CMOS battery may be flat (check the time),
Question about MSI Computers & Internet
...JBAT jumper and removing the battery, to testing the RAM on a separate PC but still no result. The RAM works correctly on another pc. I have removed the graphics card but still no post. Disconnected ...
...JBAT jumpers from 1&2 to 2&3 and returned to 1&2 - that didn't work. What else - short of taking my system to a repair shop - can I try to get rid of this error? Thank you. If you have another ...
23 questions posted
Usually answered in minutes!
33 Questions
18 Questions
9 Questions
11 Questions
10 Questions