Polycom SoundPoint IP 501 IP Phone "sip settings" Questions

polycom ip501f error, application is not present Make sure you have the latest BootROM and SIP config files for this polycom(sip.ld, sip.cfg, etc...) on your TFTP server. If you do not have this - ...

...the ip phone cable and reset the ip phone all setting What system is the phone on? In essence, SIP phones are a single line station, so this may lie in the programming of the system it is ...

...settings such as SIP proxy, gateway, or application layer or any configuration setting for SIP or VOIP. If any of these do exist, make sure they are turned off as these may only confuse or adversely ...

have a dial tone but cannot ring out or receive calls It seems that you have set it to silent ring to change this go to menu --> settings --> basic --> ringtype --> and select low trill or

...Settings and uploaded to the configuration server. check that out too hope this helps all the best tc Dear Sir/Madam, 1) After rebooting you can watch your ftp server and see the phone logging in and ...

...for my office? Please help Yikes man. The Polycom phones are used in just about every hosted or sip based pbx. So hard to answer without more information. Do you have a message or voicemail

......

sip, i configured that one but it display the message is failed to get boot parameters via DHCP, please give me solution. You didn't provide any information about your network which is ALWAYS required

...the password is 456. Once you are logged in, you should see several links like "General" "Network" "Sip" and "Lines". click on Lines. under "line 1", you will see the configuration for that line. ...