Fisher and Paykel DEGX1 Electric Dryer "drain back flow" Questions

back flow prevented seal has failed. The fact that your drain line is smaller than recommended, could be contributing to your problem by creating back pressure that is being released by your back flow

...back pressure to be escaped to the atmosphere, and if necessary drain water out of the hole until the plumbing pressure restriction can be resolved. This eliminates the possibility of a reverse flow ...

...4in pvc drain pipe from hood out side to floor then 90dgree elbow up through floor short peice of pipe then foil drier vent from back to pipe with clamps your air flows blocked backing heat up in ...

...drain pipe about 6 inches. Post back if you have any questions. No water detected entering machine or Pressure switch trip not detected.If after 30 seconds the control does not detect water entering ...

...drain line and no blockage. Cleaned drum sensors and filter. Checked heat exchanger. Turns off after 15 mins or so because of lint filter beeping. Help! We continuously had a similar problem with ...

...back run a test rinse/drain cycle to inspect for leaks and to verify the unit drains and spins now. ( If the problem still exist`s the Sd, "F2" or "F21" will re-appear. If so you`ll need to check the ...

...drain problems and back wash. - Verify Drain Pump operation. Unplug the washer and take the lower panel under the door off by removing the three screws under the bottom edge. With the screws removed, ...

...back of the dryer itself and make sure you get good air flow (exhaust) there. If you don't get any or very little flow with the vent off, chances are likely you have a broken blower wheel. These are ...

...drain and spin and all the water drains with no problem, can any help with what might be wrong? could have a problem with the flow meter or the pressure switch,send model number and i can look it up ...

drain the water (won't be much) and dry area with paper towels. take out the condensor and clean it while you are about it. feel round at the back and youb will find a small hole for the condensate to