Denon AVR-485 Receiver "setting speakers" Questions

onkyo mute channels. When turned on, one or more channels remain mute. Acts like a contact problem; when switched on-off-on multiple times, mute channels may vary follow this steps and fix it. God ...

...speakers. Try setting play back to AFD ProLogicII, Movie, or Music. If this does not get the speakers running then check the speaker configuration in the setup menu. It should be set to 5.1, if not ...

speaker impedance and the Yamaha RXV 463 I have 2 sets of speakers that I'm wanting to connect to this amp. One set is 4 ohms (old speakers) and one is 8 ohms. Can I do this? The manual indicates that

...speakers L, subwoofer has to be set additionally in the subwoofer setting. 3 test subwoofer on alternative device to test it is working ok consult manual on enjoying surround sound and adjusting the ...

...not playing back speakers not playing The problem can be the cable or speakers or RX-V463 or settings. Need to check one by one. Set the RX-V on DTS or Dolby Digital 1) Check Cables - connect ...

speaker mode - that depends on the specific speakers you have. You can define for each of 5 speakers if they are Large/Small/None (on this setting depends where will be the lowest bass tones directed)

...speakers in my living room to my AV receiver. I have the setting set of 5CH ST, because if I go on stereo, the front speakers don't make any sound at all. My problem is that my front speakers are not ...

...setting to add the rest of the speakers (Note that if one rear speaker has a bad connection), it will not allow you to use any of them). Make sure all your speakers for the surround are set up to (A) ...

...speakers and other peripherals (TV, DVD et al). After an hour turn on AV and turn volume to MAX, If the AV remains on, turn down volume to min, switch off AV and reconnect all devices. Make sure the ...

...setting and rifled through all the preset audio settings. No matter what I've tried, the Front speakers are far softer than all the other speakers. Is this an amp breakage or a settings ...