iRobot 5900 Scooba Robotic Wet/Dry Vacuum "putting down" Questions

...the handle down it turns on the brush roll. you may need to clean the brush roll or replce it if the bearings are bad.also clutch and 2 belts are started when putting handle down for brush

...putting the housing together. Have the piston on the screw threads, put the knob on the water only setting, then after the piston is on, turn slightly so it doesn't come off, just before you put the ...

...putting down just a small amount but people think its not extracting any when the real problem is not putting out enough water. If that's not the case make sure there are no clogs or suction leaks ...

my dyson handel has been put on upside down how can i fix it the handel on my dyson was put on upside down and I need to know how to fix it. thankyou Turn it over, duh

The directions say that the bottom filter should be cleaned every six weeks or so. It becomes clogged each time we vacuum Your seal on the bottom door that dumps the dirt is not properly seated. It is

loss of suction do not connect to electricity at this point claim a little work area put a blanket down as you are going to strip it all down into little bits clean and then put it all back, Take ...

...down and turn the knob at the top of the reservoir, this will begin putting cleaner (tons of foam) onto the carpet. Just work in 3' x 3' sections, turning off the foam intermitently until you are ...

wear do you put the water Inside the main tank is another container for clean water. To fill it, lay machine all the way down. Lift handle and remove container. Take to sink, turn handle, and remove ...

How do you put the vacuum back to be in position to vacuum Where the lever or button or whatever to put it in the vacuum position to begin. It's a ball and It's purple you have a dyson ball vacuum and

Took bag completely off and now I can't put it back together Took bag completely off and now I can't put it back together Put the outer bag back on the unit.  Make sure that you have pushed ...