Presto Scandinavian Design Coffee Maker "hot pot thermal switch" Questions

...hot wire and element. Check to see if you are getting power through this switch. My pot's aluminum the heating tube was blocked by mineral deposits from the tap/bottled water. Try brewing a couple of ...

...hot. Pot is only 8 months old. Either you have a corroded electrical connection (probably in the plug) or an element is bad. Try cleaning both ends of the removeable plug until they are shiny. Found ...

pot does not keep the coffee hot anymore. I cannot see how to open the pot to let the liquid out and clean it. It has been a finicky coffee maker since I bought it last Christmas - it sends coffee all

...pot is left without use for a week or so, the thermal fuses will blow if the top of the tank gets too hot (about 150 degrees Fahrenheit) due to the evaporation of water in the storage tank. The ...

...hot My BUNN coffee pot worked until today the water came thru to pot but it was cold it is turned on Don't know the model but here are things to check prior to calling your vendor for service: * ...

...pot was correctly filled, but the water did not get hot and neither did the hot water dispenser spigot. is there a fuse or a reset or must I replace a heating element? Thanks, Bob W. Check the ...

pot perc's and it gets hot near the thermo, the thermo turns off the main element. The keep warm element is not on so after a small amount of time the water cools and the thermo turns the main element

...hot. Cleaned with vinegar and baking soda, but no improvement. First, I'm NOT a Farberware technician, But if this is the table top purculating and dispenser urn then it's pretty much work the same ...

...pot on top of them. The pennies will get hot so don't forget and grab them but the pennies help to move the pot just a little way away from the direct heat. Whe a pot of coffee is done brewing, Lift ...

...hot pot wont turn on,,its like new and rarely been used I've got a Betty Crocker BC-1762 Hot Pot that also won't turn on. There's a connection between the switch and the heating element ...