...wind tunnel belts? How do you change the Hoover wind tunnel vacuum cleaner belts? If you turn the vacuum over there will be (4) screws that hold on the base cover for the roller brush. Remove the ...
Question about Vacuums
There was a flash when i was vacuuming, and now the roller brush does not turn. Do I need a new roller motor? Hoover wind tunnel uh72400 Not if the roller motor still turns - check it out!
...Wind Tunnel vacuum cleaner runs for a minute or two then turns off. (It does not respond to the on-off switch on the handle.) It will start again after a few minutes. The side filter has been removed ...
...Wind Tunnel Both of my belts work, however, it seems the roller won't roll. I have the switch turned to carpet and both belts are running, but burning while running because the roller doesn't want to ...
...belt 3. install new belt on motor spindle first and then on roller. 4. pull roller, stretching belt, set into roller cavity. 5. turn roller by hand to center belt. 6. reinstall bottom plate.& ...
...Wind Tunnel 2 Making Noise While Operating My wind tunnel 2 is making some sort of rattling noise around the base of the unit. How do I check what could be causing this? Vivek sounds like your brush ...
...wind tunnel mach 7. Hard to push (roller not really turning). I opened everything up and cleaned roller. Now roller seems to turn ok but still have the burning rubber smell when vacuuming. The belt ...
Question about Hoover Vacuums
Wind Tunnel U6485-900 will not push forward but suction works? How to get manual push to work? Vacuum sucking is okay. sounds like something has got caught in the wheels/roller. Turn unit off, flip it
...wind tunnel. (12 amps) how do i fix it? Make sure the vacuum is on the carpet setting..the brush won't turn on the hard floor setting.. take the brush roller out of the vacuum and hold on to the ends ...
21 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions