Nintendo DS Console "bent game slot pins" Questions

...bent pins inside the top slot (SLOT 1). Remove the battery by removing the battery cover on the bottom (held ny a screw). Shine a small torch into SLOT 1 and look inside to see if any of the pins are ...

...game This is usually due to either bent or dirty pins in the card slot, look inside and see if any pins are bent, if they are a new card slot is needed. Hope this helps OverLode is correct,that ...

...game slot might be bent (shine a light in the slot and use a needle or pin to straighten any bent pins) or the pins might be dirty. slide something thin, wet with rubbing alcohol, over the ...

...game slot may have bent pins or broken pins. Bent pins can be easily fixed (with care and patience) but replacing the SLOT 1 or the touch screen is quite difficult. It is probably repairable but only ...

...bent pins in the game slot, which means a new slot. This is a fairly easy thing to do if you have a small solder iron and some skill. Or corroded/ dirty pins, which you might be able to clean with ...

...game This is normally due to the pins inside the card slot being bent or dirty, try blowing into the slot or looking inside to see if any of the pins are bent, if they are a new card slot will be ...

...game at fault. Then get a very bright light and look in the slot to see if there are any bent pins, if all looks ok then you could risk some very gentle cleaning of the pins. Remember those pins will ...

...game slot Check to make sure none of the pins inside the slot are bent. If any are you will require a new card reader which is pretty difficult to install. If they are not bent try blowing into the ...

...game slot or a bent pin. Sometimes it can be the game contacts are a bit dirty but if its the same with all games then its the slot pins. It is sometimes possible to clean the pins in the slot with ...

...game..so i check the slot 1 and the pins are bend...how do i put i to normal...i dont have warrenty Its difficult to repair that without right tools, and even with the tools is still hard to do it. ...