...2 for the power cord, and 2 for the power head). These wires all pushed into the switch through 6 seperate holes. I was able to remove the wires without any problems. However, the switch that I ...
...power switch. 2 black leads and 1 white lead for switch. Posts marked 1, 2, and 3. 2 black wires to switch powers on. Connect white wire and breaker trips. Where does the white wire go? Both black go ...
...the vacuum continues to run in non-powerhead-activated mode. Sounds like you have wires crossed at the switch. The 2 wires coming in go to the center posts, 2 to the power head & 2 to the main
...2 blue wires.thanx for any help. Are you talking about the power switch. The new power switches have 4 wires sautered to the power switch, where the old ones have 6 wires that slip in and lock into ...
...2 throw on off switch has failed on the 120 V motor side of the switch. One side of the switch is for the main motor and the other is for the power to the power head socket on the vacuum it self. The ...
power It could be the switch button that you push to turn it on (2031199), or the switch (2031243) could be the problem. If not those 2, then the cord could be bad or even the motor (2031214). I would
Question about Dyson Vacuums
...power switch. I have the Dyscon DC 07 Animal. Any suggestions? If this were mine I would take the old switch off and put a toggle switch from Home Depot in it. Make sure it's rated for 110 volts and ...
Question about Kirby Vacuums
...power light clip on to on the kirby legend 2 1984 I took it apart and when putting it back together all went well but I can't figure out where the power light clips on to The light clips into the top ...
power switch Can anyone provide a guide as to how to change the power switch (red up & down type) & the part number to buy a replacement, many thanks. here is a video that will give you full ...
577 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions
146 Questions