...switch B1/13 have closed on switching steps 21/22 or 11/12. Cause: Heater relay defective; contact open. Remedy: Replace the heater relay. Cause: Heater relay solenoid defective. Remedy: Replace the ...
relay lever try to switch the flow of the water to the exhaust cycle. Alternately, remove the exhaust hose from the garbage disposal and place it in a bucket or bowl. After the water stops coming out,
Question about Whirlpool Dishwashers
...switch checks good. Display panel indicated the heat cycle is on but the relay does not pull in. No power out of the relay on the control board. The coil on the relay might be bad. Control Board ...
...was working fine but now will not do anything the light is on and ilooked inside and one of the relay switches dosent move if i push it in it goes could it be the relay ...
relay (it should be obvious as there should be scorch marks) 2. If the two separate connectors above are swapped on reinstallation it will appear that there is no power so before removal of the wiring
...switch, ok. Check heating element, Ok at 14 ohms. Got to thinking, the Logic part of the mainboard must be working. It diagnosed itself. Remove K3 relay from W1019358 main electronic board. Took the ...
...switch for blockages and correct switching point. Cause: Heater relay defective. Heater relay (coil or contacts) becomes defective during the drainage step (after fault code F51 register check). ...
switch, or bad heater relay on the main control board. Check for continuity on the heater element to rule out a burned out element. Do the same for the door switch, if all checks out good then replace
Question about Hobart Dishwashers
...480 volt even during wash cycle or when sitting idle. A constant electric supply normally means the relay that switches the component is faulty. This would normally be the timer or relay board, ...
118 questions posted
Usually answered in minutes!
445 Questions
106 Questions
41 Questions
48 Questions
27 Questions