Reddy Portable Forced Air Propane Heater w/ Variable Heat Ouput "flame" Questions

...minutes then shuts off tries to re fire a few times then goes to 2 blinks=cannot sustain or detect flame. There is a flame sensor located in the last burner that lights up. It is either not seeing ...

1985 evcon forced air furnace no ac My evcon furnace will not hold flame after eight seconds it shuts the gas off and then restarts agian over and over any help? Most likely your flame rod is either ...

dimplex cadogan no flame no flame pilot no flame main burner no flame pilot at either flame at one and not the other

low flame signal my goodman heater struggles to turn on and 7 flashing lights come witch indicate low flame signal,what does this mean and how do i fix it? There is a small probe that is located ...

Goodman furnace furnace starts,flames start and shuts off after 10 sec. Replaced flame sensor still have same problem furnace acts like flame sensor is bad, but will not code. Replaced flame sensor no

lennox intermitent flame problem I have a lennox furnace without a pilot lite, it will glow and the flame will start and then shut off immediatly, sometimes it works fine and then it has problems. The

Flame Sensor for Sit630 Eurosit model 0630535 I cant find just a flame sensor part which is what the heating guy said i need. Brings me to the hole mechanism. Which is the gas control valve. So is the

Flame sensor light blinking on my Frigidaire furnace The flame sensor is really a flame rectification circuit. Ground to the circuit board is actually conducted through the flame to the flame sensor ...

low flame signal when the heater kicks on the flame only last seconds then it turns off by its self then it returns on and off and continues to do so until it finally stays on this is not normal and ...

FLAME SENSOR FLASH FLASHING FLAME SENSOR CODE, HAS NEW BOARD AND SENSOR ON IT. A flame sensor simply "senses" a DC rectified signal from the AC spark being passed through a flame(the pilot) thus ...