Hotpoint Ultima WF860 Front Load Washer "clear filter" Questions

...must remove the front, bottom panel to gain access to the Drain Pump and Filter. Disconnect the Filter and Drain Hoses and clear them out. If they are clear, you may need to replace your Drain

...clear but have you checked the fine filter which is just inside the inlet port of the machine? Might be worth a try. If that is clear then it could be that the hot water inlet valve is malfunctioning ...

machine states the filter needs to be cleared but ... Machine states the filter needs to be cleared but i cannot locate it. Hi, It is easy to clean it if it is front load there will a small door will ...

...filter is clear you may have an obstruction in your drain, clear the drain and the washer should be able to pump out the water again. If both are clear and it is still not pumping out, check voltage ...

...filter and extract and ensure is clear. Poke your finger up the main drainage hose form the filter recess as coins can get stuck there sometimes. After clearing everything out try a dummy spin cycle ...

...clear still nothing on my kenmore machine nd means the drain filter is clogged. open the cover, drain water completely, remove and clean the filter, replace filter, tighten and close cover. hope this ...

...clear refit the filter and check the drain hose and were it drains to. Make sure all this is clear as well. Then retry the washer and see how it goes from there. If you have cleaned the drain out and ...

...wont spin...any advice? you need to check/clear filter, its located within sump hose @ bottom of drum quite trickey clip to remove slide it to the side to assist then withdraw nylon filter and

...filter was clear, but my Duet still wouldn't clear the water from the drum. When I pulled off the drain filter cap, I got a trickle (not a GUSH as you normally would) of water, indicating that the ...