...remove the little panel at the back 4 screws. you do this so you can adjust the belt to sit on the last grooves on the motor pulley.. Now to get the belt you have to do it from the top if your doing ...
Question about Fisher and Paykel Washing Machines
...and remove any lint. Replace in reverse order. HINT Some water will run from the pump port, so a towel is handy to stop splashing and to prevent water going into the flywheel. Good ...
remove the screws on the back panel. Next watch out for any edges they are sharp!, I have scars to prove it. Ok you will see a flywheel with a belt attaching it to a motor. Grab the flywheel and apply
remove the screws holding the back panel or cover. look for flywheel that is tight yet shows movement side to side and or water leaks, rust or stains. Expect 500 to fix this problem. Before you do and
...remove large bolt in center of flywheel (rotor) back bolt out until you are able to pull rotor off by hand remove 4 5/16 bolts holding stator(coils) to bottom of washer tub carefully lower stator to ...
...back on the flywheel screw and tap it with a mallot hammer to release the metal drum with metal drum removed get a metal bar to knock out the bearings also check the shaft on the metal drum for wear ...
...remove it , you notice a large nut holding the flywheel on inspect closely as there may be some securing tags (large washer with folded edges stopping the nut from comming undone ) remove nut , you ...
...remove the lower panel there are 3 torx screw that hold it on and look at the struts that attach to the bottom of the tub to the floor of the washer. One of the struts may be broken. That would cause ...
Question about Fisher and Paykel Washing Machines
...back together with new fuse but once I start to use the machine the fuse get blown out at spin cycle and sometimes it complete the wash successfully and last trigger to turn the system off will blown ...
...flywheel looking dohicky) pull rotor of remove the 4 screws in stator (dohicky with all the wires ) carefully pull it doen ..pulling wire retainers down will allow better access..connector with all ...
60 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions