...condensor will almost certainly be blocked with lint to clean this you would have to take the whole unit off with the fan motor attached . Ther are 2 screws at the top and 3 screws at the bottom poss ...
Red light is on. Thought I had overloaded but when I unloaded it still does not work. It is a condensor front load dryer and it is in our garage. Thank you Have you cleaned out the condenser unit?
...working !! Hi, My Candy CNW136 has suddenly stopped drying the clothes. Wash cycle seems fine. I cleaned it out to make sure the condensor was not clogged but still no joy. Please help. Darren
...water from the sink tap ( or anywhere...I don't think it matters, ha ha ! ) over the blower wheel cleans it thoroughly. Cleaning out the condensor housing is a nother matter...by hand is one way to ...
...back-half cover off the machine (11 screws/hex screws in all) to have a look. I then removed and cleaned out the accumulated fluff from the transparent plastic condensor unit. It didn't appear to ...
...on every drying cycle. After research online we found that it was a blockage/drainage problem. We cleaned out the blocked condensor inside the machine, the filter, drainage pipe etc and recovered ...
...to it. Good luck I HAD SAME PROBLEM. YOU NEED TO TAKE OUT THE PLASTIC CONDENSOR CONTAINER AND CLEAN IT OUT ! ITS LOCATED ON THE SIDE OF THE MACHINE. YOU MUST TAKE SIDE PANEL OFF TO GET IN AT ...
...condensor dryer. The heat is not there and it is not pumping water into the specified area. We have cleaned filters, emptied water when needed and now it is showing that the water needs emptying when ...
low temp on both sides could be a bad comp. but ck that the fan inside freezer is coing and the one in the back . clean the coil ( condensor ) all this sholld help // if the comp is good mm
196 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions