Hotpoint Aquarius WD640 Front Load Washer/Dryer "wd440 reset" Questions

...wd440. when switched on the on/off flashes and the drying and rinse hold flash. press and hold on off button till the display panel lights up.Then press and hold the on/off button and the start ...

...wd440 washing machine stopped half way through spin,wash,rinse and spin,rinse hold and time saver lights are on but nothing else is happening at all It may be an electronic issue.  To reset, ...

Hotpoint aquarius wd440 showing f12 error code how can i fix it F12 - Communication error a thing to try is resetting the machine to do this turn machine off at plug for 5 mins then back on and start ...

...WD440 washer dryer is no longer drying or heating up to dry. Any suggestions? Heater element or heater element safety thermal cutout has failed. You will need a multimeter to check. Also check wiring ...

...WD440 On / off button and time saver button both flashing Possible there is an error in the processor and it needs to be reset. You can switch off power, remove the plug from the mains and keep off ...

...WD440 it wont wash its like it dosnt no what to do all the bottons keep flashing do i need a reset code or as the board gone please help. HI IT ALL DEPENDS ON WHICH LIGHTS ARE FLASHING AS DIFFERENT ...

...wd440 Hotpoint WD640 1400spin washer dryer purchased september 2005 the dryer has never worked from new. Put the clothes into dry 3 hours later they are still wet!!! Is it still under warranty? I've ...

WD440, Rinse Hold, Time Saver and On/Off light flashing My machine occasionally freezes. It usually occurs during the final spin stage - and the machine can only be reset by unplugging it. I've spoken

The door won't open and appears loose - how do I over ride this to access my washing Hotpoint wd440 auutomatic On my machine you just hit the cancel button 2 times to reset.

...WD440 was on a cycle when we had a power failure, now the machine will start for about 1 min & then the start/stop button flashes and will not go onto a cycle. I've tried to hold down the start/stop ...