...wall, or may be located by the washing sink. Turning the valves clockwise will turn the water off. If all else fails and you cannot find these valves, turn the water off at the main shut-off in your ...
...wall and remove these spades and check the contacts for continuity, you need not remove from machine to do so, no circuit + no heat, replacement item not expensive, thats where to start based on the ...
remove that tube from its connection, now put another small tube or hose into the slot where it was and have the machine set to wash cycle with water in it. Blow into the other end of the tube. If the
remove that tube from its connection, now put another small tube or hose into the slot where it was and have the machine set to wash cycle with water in it. Blow into the other end of the tube. If the
Question about Washing Machines
remove that tube from its connection, now put another small tube or hose into the slot where it was and have the machine set to wash cycle with water in it. Blow into the other end of the tube. If the
...wall and remove the lid assembly, which was much easier than first thought. Pictures attached. Tools needed are Phillips screwdriver and Nut drivers to remove the horizontial lid/panel from above the ...
Question about Washing Machines
...wall. Disconnect both hoses from the back of the washer. Place the hoses into a bucket and turn them on to confirm that you are getting good water pressure and to clear out any debris from the line. ...
...remove his coil. GE's assembly line received new instructions: Either they buy the spintube from another source and epoxy the plastic spool holding the enameled wire down, or they ordered it to come ...
...remove the two screws in front of the filter. Grab the top of the dryer and pull it towards you on one side as you lift the front of the top. There are two clips on each side that are holding the ...
remove that tube from its connection, now put another small tube or hose into the slot where it was and have the machine set to wash cycle with water in it. Blow into the other end of the tube. If the
589 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
500 Questions
151 Questions