Hotpoint Aquarius WMA52 Front Load Washer "removing dial knob" Questions

in, when we go to set the wash. but it does move manually with finger tips The teeth on the knob are probably gone. To pull the knob off remove the clip between the knob and the dial and pull knob off

...knob and the dial. what happens is the knob has gear like teeth that will become stripped out.it is easy to replace but alittle hard to remove. you need to get a small screwdriver and go behind the ...

...removing a rear control knob on a hotpoint aquarius wma50s so ican replace abroken on the part number i have for this knob is 1603391 Yours Dennis . B to replace your timer dial take the lid of by ...

...dial. However, the way the knob is designed, there will be a lot of wear and tear on these plastic teeth, so they'll wear out on every single machine. Good luck to the many people who will have this ...

...Model washer KAWE677BW1 I believe that comes off by holding the dial firmly and turning the knob counterclockwise. The dial should pull off. Be careful, I think the dial is an obsolete

...in (I can't remember which position it should be in, but do know that it comes off by turning it counter-clockwise). With the knob off, the dial guard should lift off the center post of the

...dial manually. Thanks. Yes, stop pulling on it. Axcess the rear of the timer there will be a smaller hole with a black piece of plastic inside where the knob shaft would be if it went all the way ...

...knob/dial, removed the console (3 screws behind it), and checked where the timer was mounted to the front panel. There is only one screw holding the timer to the front panel on the left side of the ...

...knob and the inner dial. I have seen one or the other or both have the teeth ware away. See if this is the case. Part # WH01X10061 for the knob &Part # WH11X10033 for the dial. i hope this helps ...

...machine? to remove the timer knob and dial,push the knob in and turn in a counterclockwise direction the knob will unscrew completly off then place a small screwdriver behind the dail and pop it ...