...light goes off and wash cycle wont start for a front washer turning off the bulb inside the tub just only indicate that the doors is properly lock. also try to check your power source and make sure ...
Question about Zanussi Washing Machines
...inside it still wont turn. thanks tracy drum wont turn at all i had a similar problem with a zanussi machine a cheap bracelet got washed with some clothes and it found its way into the drum housing ...
...wont change cycles or turn off the lights I pressed the end cycle several times, the timer keeps flashing and I cannot get it to lock and therefore it will not start Unplug the appliance from power, ...
...inside the outlet is spinning freely. Reggadles, red light comes up. Hi, Have you tried checking the drain spigot under the sink where the waste hose connects as it can be blocked at this end? Try ...
...wont fill with water. taps are open, door is shut. Hi from retired Englishman in SW France, If you have checked that the hot water tap is turned on fully and the hose is not kinked or squashed at the ...
Question about LG Washing Machines
...light keeps flashing and there are clothes inside waiting to be washed put outlet hose on ground drain water out ,then between the handle and the manchine theres a hook put something there to pull it ...
light keeps flashing? possilbe problems? I've cleaned the compartment at the bottom from hair, hairpins, coins etc... But the problem is, washer sometimes starts without any problems, and does the
Question about Hotpoint Washing Machines
...light comes on....when it has filled with water the machaine will not do its wash...ive changed the door lock unit inside hoping that will fix it but when i switched it on again ...it done it ...
Question about Kenmore Washing Machines
...wont start. to unlock the controls select and hold drain/spin for 3 seconds until the control locked status lights turn off. To Manually unlock the door lock system: 1. Unplug the power cord from the ...
...wont run. Replacing motor because of damaged commutator. what esle could it be? I reconditioned commutator and replaced brushes. Noticed old brushes had sliced into the middle of the commutator looks ...
55 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions